remove unwanted facial hair in minutes. With a unique brush applicator for precise and easy use, you simply brush on and rinse off to leave skin beautifully smooth. for hair that is especially coarse or hard to remove, soak the hair with warm water for several minutes before application, pat dry and then apply cream. Preparation Carefully fill a cup or glass with just boiled water. Put the tube of wax, cap downwards, into the water for 2-3 minutes. NOTE: Do not submerge completely. Leave the end of the tube exposed to allow safe removal from the water. Do not exceed 3 minutes. Remove the tube from water and dry well. Remove the cap and screw on the roll-on applicator (keep the cap for storage between uses). Squeeze the tube to get the wax flowing, and roll the applicator over the back of the hand to test the wax temperature. If the wax does not come out easily, replace the cap on the tube and put it back into the hot water for 1 minute. Make sure that water does not get into the tube, as it will make the wax less effective. Hair Removal Before each use, always do a patch test. Apply a test sample to a small area where the product will be used, following the instructions. Wait 24 hours before applying the product to a larger area. A slight reddening of the skin is normal for several hours after waxing. In cases of more extreme reactions, discontinue use immediately and do not proceed with the full treatment. If skin appears normal, proceed. Cleanse the area from which you wish to remove hair using soap and/or warm water and then dry thoroughly. The hair removal area must be dry and free from any traces of cream or cosmetics. Roll the applicator over the area to be treated, in the direction of hair growth. Place a cloth strip on the wax, pressing well, leaving approx. 1cm at the end to make it easier to remove. Hold the skin taut with the other hand and then pull off rapidly in the opposite direction, parallel to the skin. Each strip can be used several times. Tips for Eyebrows For more precise hair removal, the cloth strip can be cut to your desired shape. Use the wooden spatula to separate the hairs to be removed. For a more precise application the same spatula can be used to apply the wax to a specific area for well-defined eyebrows. Roll the applicator from the centre of the eyebrow outwards, following the natural shape. After Hair Removal Any residue remaining on the skin can be washed away with lukewarm water and a clean cloth. Unscrew and remove the roll-on applicator, replace the cap on the tube, wash the roll-on applicator thoroughly under warm tap water. Wash cloth strips with warm water so they can be re-used next time. Warnings Do not directly heat in the microwave or in a saucepan. Never reapply wax to the same area within a 24 hour period. If the skin to be treated is not held taut while the strip is removed, or the strip is not pulled pack quickly and close to the skin, a pinching effect may be felt or skin could be removed, resulting in injury. Cautions The wax is less efficient on short hairs. Wax should not be used by people su